Why does 192.168.1.1 traffic from my clients defaults to "unclassified"

Discussion in 'Tomato Firmware' started by fefrie, Jul 9, 2018.

  1. fefrie

    fefrie Networkin' Nut Member

    untitled.JPG I've made the most absolute simple rule possible to classify traffic, yet it still goes to unclassified.

    If I look at some of the other traffic that becomes unclassified for other ip addresses, the classification system seems to be a bit 'leaky' even for traffic that is going outbound to the modem.
     
  2. koitsu

    koitsu Network Guru Member

    Is that traffic not 192.168.1.168-portrandom --> 192.168.1.1-port80 i.e. you accessing the router's web UI? If so, unclassified sounds pretty reasonable.
     
  3. AndreDVJ

    AndreDVJ LI Guru Member

    Any traffic that stays in the LAN can't get classified. For that IP address like your gateway you can tick an option "Exclude Gateway Traffic". You can't get rid of the unclassified section in the pie chart though.

    Whatever traffic that actually gets routed from whatever is your LAN interface like br0 to WAN interface (vlan2) and back, should get classified.

    QoS in Tomato is not perfect, has some issues, but does its job mostly fine.
     
    rgnldo likes this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice