1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

WAP54G v3.1 act not working please help

Discussion in 'Cisco/Linksys Wireless Routers' started by darkhack, Mar 12, 2018.

  1. darkhack

    darkhack New Member Member

    hello everyone
    i have a problem in my router wap54g v 3.1 it stopped working the green light not working (act) is there any sollution for this problem plz help here is a pic of the issues its stay like that

  2. darkhack

    darkhack New Member Member

    please help any one know the sollution thanks in avance
  3. darkhack

    darkhack New Member Member

    no one hekp me:(:(:(:(:(:(:(:(:(
  4. Ole Juul

    Ole Juul Networkin' Nut Member

    Sounds like an electronics problem. Could also be the cable. Try another one. Also, in case you don't get it working, the older Linksys 54G routers (assuming that's what you prefer) and other routers can also be set up as access points.
  5. Sean B.

    Sean B. LI Guru Member

    Try another wall wart ( power supply ) of the same polarity and output rating, just to be sure it's not a power issue.
  6. darkhack

    darkhack New Member Member

    thanks guys but its not a power issue i think that is the firmware cant load any one can help with how to flash it again with the same version of firmware??????
  7. Sean B.

    Sean B. LI Guru Member

    I would suggest first to try a hard reset. With the power turned on, hold the reset button on the back of the router for 30 seconds, then release. Router should reboot, if not shut it off then back on. Check if there's any chage.

Share This Page