1. This site uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

One Tomato Router, two subnets, how to bridge?

Discussion in 'General Discussion' started by mainer82, Feb 13, 2016.

  1. mainer82

    mainer82 New Member Member

    I have a Netgear WNR3500L running Tomato. I want the wired devices to have their own DHCP range and the wireless have their own while maintaing the ability for both networks to communicate.

    What I've done so far is the following:
    Basic > Network
    Bridge STP IP Address Netmask DHCP IP Range (first/last) Lease Time (mins)
    br0 Disabled 192.168.168.1 255.255.255.0 Enabled 192.168.168.20 - 35 1440
    br1 Disabled 192.168.178.1 255.255.255.0 Enabled 192.168.178.20 - 25 1440

    Advanced > VLAN > Wireless
    Bridge eth1 to LAN1 (br1)

    This has accomplished the goal for separting the DHCP ranges however wireless can't ping wired and vs. I want them to be able to communicate. What am I doing wrong?
     
  2. mainer82

    mainer82 New Member Member

    I can now ping from br0 (wired) to br1 (wireless) but I can't ping a wired device from wireless which I need.

    What I did was in Tomato > Advanced > LAN Access
    On Src Dst
    On LAN LAN1

    I tried to reverse that and it did not work for wireless to wired.
     
  3. pegasus123

    pegasus123 Networkin' Nut Member

    bumping this up, seems im seeing the same with my setup 2 br's.

    br0 to br1 - able to connect
    br1 to br0 - not possible.

    I have already setup the Lan Access page.
     

Share This Page