Changing from NTFS-3G to Paragon driver

Discussion in 'Tomato Firmware' started by brav, Oct 9, 2018.

  1. brav

    brav Addicted to LI Member

    Using AndreDVJ's fw on an R8000-I'm getting pretty slow USB 3.0 speeds and wanted to try using Paragon's driver. I can't seem to change the options on the "NTFS Driver" slot-do I need to install Paragon's drivers first? Thanks!
     
  2. Sean B.

    Sean B. LI Guru Member

    NTFS-3G is a filesystem driver. It does not affect the speeds obtained by the USB 3.0 port itself.
     
  3. AndreDVJ

    AndreDVJ LI Guru Member

    Yes you can't, and it's on purpose. Long story short, R8000 isn't licensed to use Tuxera driver that's available in SDK7. Paragon isn't available as an option because the binary blob isn't there.
     
  4. brav

    brav Addicted to LI Member

    Ok, thanks for answer. Any other ways to improve USB3 speeds on my external HDD? When I try to stream videos from the HDD connected to the router, I get a lot of skipping. Thanks!
     
  5. AndreDVJ

    AndreDVJ LI Guru Member

    Genie is the only solution for USB3 speeds in R8000 unfortunately. That's among the reasons my R8000 here is my spare router.
     
  6. brav

    brav Addicted to LI Member

    I see..ok thanks for your help!
     
  7. Monk E. Boy

    Monk E. Boy Network Guru Member

    ext3 should be faster than ntfs though I don't think it'll be night and day faster.
     
    koitsu likes this.
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice